Topology Optimization: Using Multiple Objectives

Follow

Group_20optimization_objective.png

More than one objective can be considered in TopOpt by populating the Design Response List in your Optimization Objective block with more than one design response. Multiple objectives can be used to consider the response of a part to several different loading cases a part may experience. They can also be used to balance an optimization based on both displacement response and compliance, for example. The importance of each objective can be given a weighting factor using the Weights input, based on the following equation. If the weighting input is left empty, the multiple constraints will be equally weighted.

2.PNG

3.PNG 

Check out these articles for further topics on Topology Optimization:

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Article is closed for comments.