Like any block in nTop, you can look in the Info Panel under the Information tab for information on what the inputs to a block do, but this section will provide additional information and tips on how to use TopOpt settings.

Max iteration - TopOpt is an iterative process that updates the topology until the objective is reached and the constraints are satisfied. If the process is taking a long time, the user can set a maximum limit to the number of iterations attempted. This input allows you to limit the max computation time expended on the TopOpt process.

Min objective Change - The objective function is a quantified measure of how well the topology is achieving its objective(s). When the relative change between iterations of the objective function falls below this number, the TopOpt will be considered complete (as long as the constraints are satisfied). Decreasing this number will result in a more accurate TopOpt, but longer computation time.

Min density change - This input is a convergence threshold, like described above, but for the relative change of the elements TopOpt density from one iteration to the next. Decreasing this number will result in a more accurate TopOpt, but longer computation time.

Boundary Penalty - This input controls how the TopOpt deals with setting density values at the edges of the design space.

The 1 option sets the TopOpt density to 0 along the edges of the design space. The material will be completely restricted on the boundary where no loads or constraints have been applied. This option works well if you set up your design space to have a buffer zone of nodes on the outside of the space where you know that no material will be filled in.

In some cases, you may anticipate that your part will end up including elements on the outer edge of the design space. This is likely true if you are doing TopOpt on a coarse mesh. The 0 option defines TopOpt densities at the design space edges such that the gradient (the spatial derivatives in x,y,z) will be zero. This allows you to have non-zero TopOpt densities at edges. No penalization is enforced on the boundary in this case.

The overall recommendation is to use a small enough mesh size so that the 1 option can be used and density can be 0 at the edges, but if needed, option 0 provides an alternative. The image below shows how results can change between different Filter Boundary options.

Filter Size - This optional input specifies a minimum feature size that will be present in your TopOpt result. Note that it can accept a field input, meaning you can choose a spatially-variant scalar field as your minimum feature size. If this optional input is left blank, we assume a default value of 2 times the average element size.

Initial Density - This optional input can take in a scalar field of TopOpt density values (from 0 to 1), which will provide the initial guess at the TopOpt result before the process begins. When left blank, the TopOpt densities are set to 0.5 at all elements.

## Comments

Article is closed for comments.