I ran a simulation but my results don't show up as expected

Issue:

I ran a simulation, but my results for the Von Mises stress don't register on the part, it shows solid purple. Changing the Boundary Conditions gives me the same result.

Cause:

This can occur due to the upper bounds of the Stress HUD.

Solution:

Edit the values in the HUD to show the results on your part. 

hud.jpg

More on this topic:

Keywords:

 error analysis simulation static design stress strain results point displacement von mises HUD issue 
Was this article helpful?

Comments

0 comments

Please sign in to leave a comment.